Installing The Pedestal - Whirlpool W10325308A Instructions D'installation

Installation of new washer/dryer
1. Unpack the washer/dryer and move close to the intended
installation location.

INSTALLING THE PEDESTAL

Installing the pedestal on the washer
1.
Place washer on its side
To avoid floor damage and ease installation and handling, fold
the empty pedestal box flat and place it next to the washer.
Position the drawer divider so that it will be near the top of
the washer, as shown. Gently tip the washer on its side so
the washer is resting on the drawer divider.
Drawer divider
Pedestal box
2.
Prepare the washer
Washer
bottom
Partially install two of the #12 x 5/8"
hex-head sheet metal screws in the
indicated holes. Leave a space of
about 3/8" (10 mm) between the
screw head and the bottom of
the washer.
NOTE: If your washer has leveling feet installed, remove them.
Do not install the feet that came with a new washer.
3.
Attach pedestal to washer
Move the pedestal against the washer bottom. The front of
the pedestal cabinet should align with the washer cabinet as
shown below.
Slide the pedestal's keyhole slots back over the lower two
partially installed screws.
Pedestal
view from above
Washer
Front
5