Service And Repairs - Leister EXAMO 300F Instructions D'utilisation

Version Tensiometer
EXAMO 300F / EXAMO 300F with USB-Port
EXAMO 600F / EXAMO 600F with USB-Port
Maintenance
• Keep drive shaft (6) clean and grease after 40 hours of operation. When using under difficult environmental con-
ditions, the intervals have to be reduced.
• Keep guide bars (7) (8) clean.
• Friction bearings as well as shaft bearing are maintenance free. Lubrication with grease or oil (with grease addi-
tives such as Zinc Sulphide, Molybdenum Sulphide and similar) is not allowed as this would affect the working life
of the bearings.
• Damaged wiper devices on the sliding carriage (12) have to be replaced immediately.
• Check power supply cord and plug for any possible electrical or mechanical damages.

Service and Repairs

• The carbon brushes in the motor should be checked by your Service Centre after about 1000 hours of operation.
• Repairs have to be carried out by authorised LEISTER Service Centres only. They guarantee a specialized and
reliable repair service within 24 hours using original LEISTER spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of
guarantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced
by the distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery
document. Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper hand-
ling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
28