Service And Repairs - Leister EXAMO 300F USB Instructions D'utilisation

Maintenance
• Keep drive shaft (6) clean and grease after 40 hours of operation. When using under difficult environmental
conditions, the intervals have to be reduced.
• Keep guide bars (7) (8) clean.
• Friction bearings as well as shaft bearing are maintenance free. Lubrication with grease or oil (with grease
additives such as Zinc Sulphide, Molybdenum Sulphide and similar) is not allowed as this would affect the wor-
king life of the bearings.
• Damaged wiper devices on the sliding carriage (12) have to be replaced immediately.
• Check power supply cord and plug for any possible electrical or mechanical damages.

Service and Repairs

• The carbon brushes in the motor should be checked by your Service Centre after about 1000 hours of operation.
• Repairs have to be carried out by authorised LEISTER Service Centres only. They guarantee a specialized and
reliable repair service within 24 hours using original LEISTER spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case
of guarantee or warranty claims any manufacturing or workmanship defects will either be repaired or repla-
ced by the distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a
delivery document.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper
handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
28