Leister EXAMO 300F Instructions D'utilisation page 20

Readiness for working
• Open storage case
• Connect enclosed power cable to socket (1).
• Connect the machine to the line/mains
• Pull out clamping lever (9) un till it is locked
• Turn-on main switch (2)
– Position of sliding carriage is not at spacer (13)
– Position of sliding carriage is not at spacer (13)
Test parameter
• Set the test parameters using the following keys:
SET
–
Set Speed ‹ ‹
• Speed:
• Initial Length:
• Initial Tension: Level of initial tension. When the set initial tension is achieved, the evaluation of the tensile
test starts. If the initial tension is set to O N, the test evaluation can be started by pressing the
• Exit menu by pushing
• When setting the initial length, the force display may show the value 0. Reason: Influence of temperature on
the equipment and/or force on the clamping jaws (11) which are close to the housing of the drive motor
and circuit board (15).
• When starting the test, the force values are reset to 0.
Version with USB port has more menu items (see operation of USB port).
20
– Press < <, for Initialize appears on display (4)
– Push key
and sliding carriage (12) moves to spacer (13).
– Display (4) shows standard mode
– Display (4) shows standard mode
SET
+
› › Set Initial Length
Test speed in mm/min.
Jaw spacing in mm, which is automatically adjusted by the equipment when pressing the
–
key or + .
‹ ‹ › ›
The jaw spacing can be corrected at any time with the key
The absolute position of the sliding carriage (12) (jaw spacing) appears on the display (4).
key
SET
–
, Wait for Initialize appears on display (4)
‹ ‹
–
‹ ‹
SET
+
› › Set Initial Tension
–
‹ ‹
–
+
‹ ‹ › ›
+
or .
› ›
Start key.
›
■