Toshiba Carrier MMD-AP0074SPH2UL Manuel D'installation page 11

<Under air intake>
0.5"(12.5)
3.9"(100) 3.9"(100) 3.9"(100) 3.9"(100) 3.9"(100) 3.9"(100) 3.9"(100) 3.9"(100)
Alteration from the back air intake to the underside air intake
Remove the cover plate from underside. Attach the cover plate to back air intake side.
The intake flange provided (for air intake from the back) cannot be used for air intake from the underside.
Remove the cover plate and then fix
it to the air intake side
19-EN
31.7"(805)
0.5"(12.5)
32.5"(825)
CAUTION
Take out this cover
plate.
Connecting method of the duct
Heat insulator with sticking material (locally procured)
Aluminum tape (locally procured)
Flange
Duct: Insulation
materia
(locally procured)
Air discharge side
Aluminum tape
(locally procured)
Heat insulator with sticking material (locally procured)
CAUTION
Incomplete heat insulation of the supply air flange and sealing may occur dewing resulted in falling of water drop.
– 10 –
Flange
Connect a duct to the
inside of the flange
Aluminum tape (locally procured)
Indoor unit
Air intake side
Aluminum tape (locally procured)
Cover a screw Under surface
EN
20-EN