Closing The Door; Replacing The Lamp; Installation - AEG S53620CSX2 Notice D'utilisation

14 www.aeg.com
Problem

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.

8.3 Replacing the lamp

1. At the same time, with the fingers
expand up and down the transparent
9. INSTALLATION
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
If the advice does not lead
to the desired result, call the
nearest brand-mark service.
The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from
the mains socket.
WARNING!
Refer to Safety chapters.
Possible cause
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
cover and unhook it in the direction
of the arrows.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light comes on.
Climate
class
SN
N
ST
T
Solution
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
1
2
1
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C