laser class
table dimensions
gross/net weight
6. Setup
Unpack the tile cutter and check it for damage which
may have occurred in transit.
Clap the table feet A (see Fig. 1) out and secure
them with tightening knobs B.
Mount the saw blade: Demount the blade protection
(see Fig. 3).
Now mount the saw blade and check for the correct
direction of the blade. Mount the protection.
Optional: In some optional versions a control lever is
integrated in delivery. Mount this lever with onto the
covering plate of the sawing aggregate!
7. Prior to Operation
Fill the water basin (G) with clean, cold water. Put
the water pump into the basin.
Check the water pipe for any bends
Remove any tool or item from the working plate.
Check the saw blade for free rotation by turning it by
hand.
8. Operation
a.
Switch on (Fig. 2)
Start the tile cutter by pressing the green button.
(Sideward's sawing aggregate).
b.
Switch off (Fig. 2)
Pull the saw blade completely out of the cutted tile
Switch the tile cutter off by pressing the red button
(Sideward sawing aggregate)
c.
Bevel setting
You can cut with the ZIPPER tile cutter in an angle
interval from 90° to 45°
Loosen the tightening knobs (F) and (H).
Tilt the entire aggregate until you reach the desired
angle (see Fig. 5 and 7).
Re-tighten the tightening knobs.
d.
Tile cutting
Place the tile to the fence (J)
Cutting line is the saw blade slot
The angle guide (C) serves as additional guide for
non 90° cuts.
Especially when using the Italian method (tiling
without joints), we recommend to measure the an-
gle with an additional tool and to mark the cutting
line on the tile. The angle guide shall serve in this
case as an additional guide.
9. Maintenance
Attention! Pull out the power plug first!
Clean your machine regularly from dust and dirt.
Cleaning is best carried out with a soft scrubber or
a clean cloth.
Do not use caustic agents for cleaning!
Change the water in the water basin after each use
Clean the basin
Check your saw blade for any cracks or damages.
Replace worn or damaged saw blades immediately.
Z.I.P.P.E.R Maschinen Austria
Operation manual ZI-FS200 / ZI-FS250
class II, EN 60825-1
mm
790x390
1090x500
kg
32/29
61/54
www.Zipper-maschinen.at
Saw blade replacement
Demount the saw blade guard (Fig. 3)
Loosen the locknut with a 12&30mm wrench.
Remove locknut and flange. (Fig. 4)
Remove the old saw blade and mount the new one.
Attention: Take care to mount the saw blade in the
right direction.
Mount the flange and locknut, tighten the locknut.
Check the mounted saw blade for eventual wobble
by turning it by hand. If wobble occurs, the flange
was not set accurately.
10. Spare Parts / Guarantee
Use original spare parts only. The use of other spare
parts renders guarantee claims invalid.
Please turn with guarantee claims to your domestic
ZIPPER merchant. He will handle your reclamation with
care and decide on further steps.
What you need for your spare part request in general:
Copy of the corresponding spare part drawing with
the desired spare parts being marked on it.
Serial number of the machine.
Copy of the payment receipt.
EN
Page 9