After Using The Cleaner; Switching Off The Cleaner; Storing / Frost Protection - Pressure-Pro PP3425H Mode D'emploi

6 After using the cleaner

Switching off the cleaner

6.1
1. Turn the engine switch to "OFF" position.
2. Close water tap.
3. Activate spray handle until the washer is depressurized.
4. Lock the safety catch on the spray handle.

Storing / frost protection

6.2
1.
Disconnect the water inlet
hose. Remove the nozzle and
empty it of water.
2.
Start the machine allowing it
to run with the spray handle
opened until it is empty of
water.
3.
Place a suction hose in a
bucket with 6-8 liters (1.5-2
gallons) anti-freeze.
4. Place the spray handle
(without spray nozzle) above
the bucket, activate the spray
handle so that the anti-freeze
can circulate.
5. Place the spray handle above
the opening of the anti-freeze
container and allow the
machine to pump all of the
solu-tion back into the
anti-freeze container. The anti-
freeze can be reused, but
keep in mind that it is slightly
diluted with water each time
this is done.
It is advisable to store the
machine in a frost proof place
between operations. If this is
not possible the machine
should be protected in the
following way:
Important:
To avoid damage always ensure
that the washer, the hoses and
the spray lance are unfrozen
before restarting. Place the
washer and the accessories in
a warm environment for some
time before starting up.
9