Before Starting The Machine; Fill Up Fuel Tank; Connecting The High Pressure Hose; Connecting The Water Supply - Pressure-Pro PP3425H Mode D'emploi

3 Before starting the machine

Fill up fuel tank

3.1
With the machine cold and turned off:
1. Fill engine tank from a clean container with fresh gas.
Use clean fuel only, free of
moisture and contamination.
Contact your dealer for fuel source
and type recommendations.
3.2 Connecting the pressure hose
1. Connect the high pressure hose quick connector to the high pressure nipple.
3.3 Connecting the water
1. Attach garden hose to water
supply.
2. Flush the garden hose
briefly in order to prevent
sand and other dirt particles
entering into the machine.
3. Attach garden hose coupling
to inlet.
4. Open water supply faucet.

4 Control / Operation

4.1

Connections

Connecting the spray nozzle to wand
4.1.1
Insert spray nozzle into wand quick connect.
4.2

Switching on the cleaner

4.2.1

Cold water operation

Before starting up the engine, you must
carefully read through the instructions for
use of the engine. In the instructions for use
the operation and service of the engine is
described.
When the engine has been started, the high
pressure washer can be used for cleaning
with cold water.
5
Maximum storage time in high pressure
cleaner tank: 1 month.
Fuel stored externally for more than 6
months is not allowed to be filled into high
pressure cleaners.
NOTE!
In the case of poor water quality
(sand, etc.), it is recommended
that an inlet water filter be
installed.
Water supply hose should be a
reinforced hose and have a
minimum inside diameter of
3/4" (19 mm).
NOTE!
Always remove any dirt from
the nipple before connecting
the nozzle to the spray gun.