Connecting Electrical Power To The Reversing Video Camera - Dometic PERFECTVIEW CAM 29N Instructions De Montage

CAM29N
• Protect every through-hole made in the outer skin of the bodywork against water penetration,
for example by using a cable with a sealant and by spraying the cable and the cable sleeve with
sealant.
I
NOTE
• Only start sealing through-holes when you have completed all installation work on
the camera and have laid the required cable lengths.
• Pull the socket connector of the camera cable through the cable bushing sleeve
before inserting the sleeve in the bodywork.
➤ Route the camera cable into the interior of the vehicle so that it cannot be damaged under any
circumstances (e.g. by gravel impact).
➤ Lay the camera cable so that should you need to remove the camera, you can easily access the
plug connection.
This facilitates the disassembly considerably.
8

Connecting electrical power to the reversing video camera

The circuit diagram for the reversing video camera can be found in fig. 6, page 5.
No. in
fig. 6, page 5
1
2
3
4
5
Connecting the camera
I
NOTE
Make sure the plug connections are assembled in such a way that the arrows on the
plug and the socket are pointing at each other (fig. 5, page 5).
➤ Insert the plug of the camera cable (fig. 6 2, page 5) as far as it will go into the 6-pin socket
(fig. 6 3, page 5) of the connection cable.
Make sure that the plastic cap of the socket reaches up to the arrow on the plug.
➤ Connect the 6-pin plug (fig. 6 4, page 5) on the connection cable to the monitor.
EN
Connecting electrical power to the reversing video camera
Designation
Camera
6-pin mini DIN plug
6-pin mini DIN socket
6-pin mini DIN plug
Monitor with 6-pin mini DIN socket
11