ARIETE 2474 Mode D'emploi page 11

- Clean the appliance body by using only a damp cloth with mild detergent, if necessary.
When cleaning the appliance, make sure that no type of liquid enters the cleaner.
Never use heavy-duty cleaning agents (stain removers or solvents) as they could corrode the
plastic.
How to empty the dust container (I)
IMPORTANT: Clean the dust container (I) and filter (L) in good time; suction power will be reduced
if the container is full or the filter is clogged.
- Press the release button (M) and pull out the whole container (Fig. 4).
- Take the filter (L) outwards (Fig. 5) and proceed with cleaning.
IMPORTANT: Only wash the filter (L) in clean water, without using soap or detergent.
- Empty the dust out from the container (I) and into a plastic bag; if necessary, rinse out the con-
tainer.
- Dry all parts and then refit them.
- Re-assemble the appliance body with the dust container, inserting the notch on the body into the
apposite opening on the container and press the latter until it locks in place (Fig. 6).
IMPORTANT: Properly assemble the filter (L) and the dust container (I) before starting the appli-
ance.
TROUBLESHOOTING
Problem
The motor is not working
Suction power becomes
weak
The charge indicator light
doesn't work
The battery use time is shor-
ter and shorter
Possible reason
Flat battery
The dust container is full or the
filter is blocked
Power supply disconnected
Charger plug not firmly inserted
There is dust between the motor
electrode and the base
If the battery is fully charged
within 8 hours
- 9 -
Solution
Recharge the battery
Empty the dust container and
clean the filter
Plug back in firmly
Clean off the dust
If the battery can only work for
1-2 minutes after a full 8-hour
charge, it may be flat and sim-
ply needs replacing with a new
one. Contact an authorized
Service Centre.
EN