Jung ZidaTech 500.600.115 Instructions D'utilisation page 9

eNet actionneur variateur 1-10 V, 1 voie mini
Operating mode
Manual commissioning
Local Operation
Behaviour on voltage return
Brightness on voltage return
Behaviour after the end of the
disabling function
Manual saving of the scene
values
82581023
J0082581023
Normal operation
Continuous on
Continuous off
Basic setting: Normal Opera-
tion
On, Off
Basic setting: On
On, Off
Basic setting: On
On
Off
Last value
Configured brightness
Basic setting: Off
0...100 %
Basic setting: 100 %
On
Off
no change
Last value
Basic setting: No change
On, Off
Basic setting: On
9/13
see Device and channels
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Blocks the output for operation
using the Prog button.
Defines the behaviour of the
output after voltage return.
Brightness value, set by the
output after voltage return
(mains voltage). The parame-
ter "Behaviour after voltage re-
turn" must be set to "Configu-
red position".
Note: If the value is above the
set maximum brightness or
below the minimum bright-
ness, then the system will
switch to the appropriate limit
value.
Behaviour of the output when
a block is removed.
Disables the saving of the cur-
rent brightness value as scene
value in an actuator for a com-
mand via a transmitter.
29.03.2017