DeWalt DW331 Traduction De La Notice D'instructions Originale page 31

Mounting the plastic anti-scratch shoe cover
(fig. D)
The anti-scratch shoe cover (12) reduces damage to
the surface of (sensitive) workpieces.
• Click the cover onto the shoe as shown.
Mounting and removing the anti-splinter shoe
insert (fig. E1 & E2)
The anti-splinter shoe insert (13) which fits close to
the saw blade reduces splintering of the workpiece.
The insert can be mounted both into the shoe and
the shoe cover.
• Hold the insert (13) in the orientation as shown.
• To mount the insert into the shoe (9):
- Slide the edges (14) into the grooves (15).
- Slide the insert back into position against the shoe.
• To mount the insert into the cover (12):
- Slide the edges (14) behind the ribs (16).
- Push the front end of the insert towards the
cover. The insert snaps into place.
• To remove the anti-splinter shoe insert do the
above process in reverse order.
Dust extraction (fig. F)
The dust extraction adaptor (17) in combination with
the dust extraction shroud (18) helps extracting the
dust from the workpiece surface, when connected
to a suitable dust extraction system.
• Place the dust extraction shroud (18) onto the
finger guard (6) until it clicks in place.
• Fit the dust extraction adaptor (17) to the tool as
shown.
• Connect the hose of a suitable dust extraction
system to the adaptor.
WARNING: When appropriate, connect
a dust extraction system designed
in compliance with the applicable
directives regarding dust emission.
WARNING: Do not use a dust
extraction system without proper spark
protection when sawing metal.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure your workpiece is well
secured. Remove nails, screws and
other fasteners that may damage the
blade.
• Check that there is sufficient space for
the blade underneath the workpiece.
Do not cut materials that exceed the
maximum cutting depth of the blade.
• Use sharp saw blades only. Damaged
or bent saw blades must be removed
immediately.
• Do not use the tool for sawing pipes or
tubes.
• Never run your tool without a saw blade.
• For optimal results, move the tool
smoothly and constantly over the
workpiece.
Do not exert lateral pressure on the saw
blade. Keep the shoe flat on the workpiece
and lead the cord away in line with the
tool. When sawing curves, circles or
other round shapes, push the tool gently
forward.
• Wait until the tool has come to a standstill
before removing the saw blade from the
workpiece. After sawing the blade may
be very hot. Do not touch.
Proper Hand Position (fi g. A, K)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (21), with the other hand on the main handle
(20).
Switching on and off (fi g. A)
DW331
• To run the tool, press the on/off switch (1).
EN GL IS H
29