Mendip Stoves Loxton 5 SE MK4 Guide D'utilisation Et Mode D'emploi page 6

STOVE PERFORMANCE & TESTING
Mendip Stoves, Churchill and Loxton 5kW models are tested in accordance with EN 13240.
Output
Wood Fuel
Churchill 5 5.0kW
Loxton 5 5.0kW
Weight & Nominal Heat Output for Wood and Smokeless Fuels
Log Length
Churchill 5
Loxton 5
Minimum Distance to Combustible Materials
Combustible materials should not be located where the heat dissipating through the walls of fireplaces or flues could ignite
it. Therefore when installing the stove in the presence of combustible materials due account must be taken of the guidance
on the separation of combustible material given in Building Regulations Approved Document J and also in these stove
instructions. The minimum distances to flammable materials are specified on the EN 13240 plate on the back of the stove.
When installing the stove 100mm from a combustible wall behind , use the additional, rear convection panel supplied
with the stove, this slots over the rear convection panel providing additional radiant protection from the flue collar. A twin
wall insulated flue should be fitted flush to flue collar for this type of installation.
Stove Model
Churchill 5
Churchill 5 Convection
Churchill 5 Convection Logstore
Loxton 5
Loxton 5 Logstore
PLEASE NOTE THAT A MINIMUM DISTANCE OF 1350mm TO SOFT FURNISHINGS SHOULD ALWAYS BE MAINTAINED
A DIAGRAM TO ILLUSTRATE THE MINIMUM DISTANCE TO COMBUSTIBLE MATERIALS
Efficiency CO@13%
81.1%
81.1%
Wood Reload
35cm 1hr
35cm 1hr
Minimum Distance to Combustible Materials
REAR
100mm
100mm
100mm
100mm
100mm
Suitable for
O₂ DEFRA Smoke
Control Zones
0.06 Yes / SE model
0.06 Yes / SE model
Weight Wood Load
1.2kg
1.2kg
SIDES
300mm
150mm
150mm
300mm
300mm
6
Output Coal Efficiency
Fuel
5.0kw 70%
5.0kw 70%
Coal Reload Weight Coal (anth)
2hr
2hr
Suitable for 12mm non-
combustible floor plate
FRONT
600mm
600mm
600mm
600mm
600mm
CO@13% O₂
0.17
0.17
1.5kg
1.5kg
YES
YES
YES
YES
YES