Mendip Stoves Loxton 8 Manuel De L'utilisateur Et Mode D'emploi page 12

BURNING WOOD IN A SMOKE CONTROL AREA -continued
Refuelling on to a low fire bed
If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke emission can occur. Refuelling
must be carried out onto a sufficient quantity of glowing embers and ash that the new fuel charge will ignite in a reasonable
period. If there are too few embers in the fire bed, add suitable kindling to prevent excessive smoke
Operation with door left open
Operation with the door open can cause excess smoke. The appliance must not be operated with the appliance door left
open except as directed in the instructions.
Dampers left open
Operation with the air controls or appliance dampers open can cause excess smoke. The appliance must not be operated
with air controls, appliance dampers or door left open except as directed in the instructions.
Fuel Overloading
The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause excess smoke
Refuelling must be carried out onto a sufficient quantity of glowing embers and ash that the new fuel charge will ignite in
a reasonable period. If there are too few embers in the fire bed, add suitable kindling to prevent excessive smoke
SE Cleanheat- smoke exemption modification
Smoke exempt models are factory fitted with a air
stop on the air control slider:
● Loxton 8 DS
● Loxton 8 Logstore DS
● Churchill 8 DS
● Churchill 8 logstore DS
12