Paul Mitchell NEUROSTYLE NS10EA Guide D'utilisation page 5

• Do not operate where oxygen is being administered to
avoid the risk of fire.
• DO NOT USE WHEN CORD HAS BEEN DAMAGED OR
IF PLUG IS LOOSE.
• DO NOT REPAIR, TAMPER WITH, OR TRY TO
RECONSTRUCT the iron, otherwise electric shock,
malfunction or accidents may result.
• When inserting or pulling out the plug, hold the plug
firmly to prevent the cord from peeling and to prevent
accidents or malfunction.
• Stop using immediately if you smell an offensive odor. If
ignored, it could cause a fire or other accidents.
• Do not use on wet hair.
• Do not keep the iron in a damp place, such as a
bathroom, or it may malfunction.
• Stop using the iron and remove from the power source
when there is an earthquake or thunder.
• Unplug the iron from the power source when cleaning or
wiping to prevent fire or electric shock.
SAVE THESE INSTRUCTIONS.
MAINTENANCE
Daily Maintenance: For the safe use of the iron, check the following
daily:
• Check the cord and surface of the cord. Never use if any parts
are cracked, split, torn or damaged
• Check the plug and never use if it is cracked, split or damaged
• Check the plug pins and never use if transformed or damaged
• Check the controller and do not use if cracked, split, broken or
damaged
• When not in use, clean and dry the entire iron and store in a
cool, dry place
7
NS10EA_NeuroStyle_book_C16_FINAL_JR.indd 7-8
When ready to use, follow the directions for daily maintenance.
Daily Cleaning: To keep plates clean, unplug the iron from the power
source, and once the plates are cool, wipe down plates after each use
with a hot, damp towel.
WARNING: Do not wipe the iron with thinner, benzene, gasoline, lamp
oil, and other solvents or chemicals, as that may cause accidents or
malfunction and may damage the iron and void the warranty.
Defects and Malfunction
• In case some malfunction is found, consumers can return the
iron to the salon where it was purchased; salons/stylists can
return it to their distributor.
• Read all contents of the warranty completely and carefully
before contacting the salon or the distributor.
• John Paul Mitchell Systems is not responsible for damage
caused by misuse or due to operator accidents, such as
dropping the appliance on the floor.
8
3/9/16 11:24 AM