SEVERIN ES 3570 Mode D'emploi page 13

Operation
Preparing the ingredients
∙ Clean and cut up the fruit or vegetable as
necessary, so that the pieces fi t down the
feeder tube. Remove any stones, pips or
cores to prevent damage to the appliance.
Preparing the appliance
∙ Ensure that the switch is set to its 0
position.
∙ Place the fi lter holder onto the drive unit
with the juice outlet to the right.
∙ Fit the fi lter into its holder, pushing it fi rmly
down by the rim until it is heard locking
into place. It is important that the fi lter is
securely attached and not at an angle,
and that it can be turned easily.
∙ Slide the pulp container on the left side of
the unit under the rim of the fi lter holder,
tilting the container slightly.
∙ Place the transparent lid onto the fi lter
holder. The left side of the lid must
engage in the pulp container. Secure the
lid with the locking clip, which will activate
the safety switch. Ensure that the locking
clip engages fi rmly on both sides into the
locking recesses on the lid.
∙ Fit the juice container with its lid below the
outlet.
Juicing
∙ Insert the plug into the wall outlet and put
the switch to the required setting.
∙ Feed the clean, pre-cut fruit or vegetable
pieces down the feeder tube while the
unit is running. When inserting the pestle,
ensure that its guide slots slide over the
two protruding knobs on the feeder tube,
and then push the pieces lightly down.
Caution: Excessive pressure may result
in damage to motor or fi lter.
∙ When processing large quantities of fruit
or vegetables, the pulp container and
juice container must be emptied from time
to time as necessary.
∙ If larger quantities of food pulp should
have accumulated in the fi lter holder,
switch the appliance off, disconnect it
from the mains and clean out the fi lter
holder.
After use
∙ After use, remove the juice container,
switch the appliance off and disconnect it
from the mains.
∙ Make sure to clean the appliance
thoroughly after each cycle of use. For
detailed information, please refer to the
Cleaning and care section.
∙ To detach the fi lter and fi lter holder,
remove the pulp container fi rst. Then
fold down the locking clip and take off the
pestle and lid.
∙ Place your left hand under the fi lter
holder and your right hand under the juice
outlet. Pull the fi lter holder up by applying
pressure to left and right alternately, until
it comes clear.
∙ Take off the fi lter holder and fi lter.
Juice container
With the lid left in place when pouring out
the juice, the foam caused during juice
extraction will remain inside the container.
13