Electrolux EFG 6416 Manuel D'utilisation page 6

6 www.electrolux.com
5. CONTROLS
The hood is fi tted with a control panel
with aspiration speed selection control
and a light switch to control cooking area
lights.Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The command of the hood is positioned on
the lower side.
The control of the hood functions is done by
means of a control knob with six positions
(see fi gure)
The control knob can be turned in both
directions
OFF
Low Speed
High Speed
speed.
speed.
Light switched on.
Light switched on with high
Light switched on with low
6. LIGHTING
Disconnect the hood from the electricity.
Warning! Prior to touching the light
bulbs ensure they are cooled down.
• Remove the grease filter. The grease
filter is released by pushing it forward
(away from the wall) and then pulling
down.
• Remove the ceiling light.
• Replace the damaged neon with a
similar/equivalent new one.
To avoid damaging the neon during
removal, place your fi nger at the end of the
neon and pull gently.
Both neon lights turn off even if only one is
damaged.
Therefore it is recommended to replace one
neon at a time (see fi gure)