Error Displays/Messages - Sony CDX-S2000C Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car's aerial booster
(only when your car has built-in FM/MW/
LW aerial in the rear/side glass).
• Check the connection of the car aerial.
• The auto aerial will not go up.
t Check the connection of the power aerial
control lead.
• Check the frequency.
Automatic tuning is not possible.
• The local seek mode is set to "ON."
t Set the local seek mode to "OFF"
(page 11).
• The broadcast signal is too weak.
t Perform manual tuning.
The "ST" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set the monaural reception mode to
"ON" (page 11).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
t Cancel monaural reception mode
(page 11).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
t Press (TA) repeatedly until "TA-OFF"
appears.
No traffic announcements.
• Activate "TA."
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays "- - - - - - - -."
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the programme
type.

Error displays/Messages

Error displays
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
ERROR
• A CD is dirty or inserted upside down.
t Clean or insert the CD correctly.
• A CD cannot play because of some problem.
t Insert another CD.
FAILURE
The connection of speakers/amplifiers is
incorrect.
t See the installation guide manual of this
model to check the connection.
HI TEMP
The ambient temperature is more than 50°C.
t Wait until the temperature goes down
below 50°C.
OFFSET
There may be an internal malfunction.
t Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
RESET
The CD unit cannot be operated because of
some problem.
t Press the RESET button on the unit.
Messages
L.SEEK +/–
The local seek mode is on during automatic
tuning (page 11).
NO AF
There is no alternative frequency for the
current station.
"
" or "
You have reached the beginning or the end of
the disc and you cannot go any further.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
"
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cdx-s2000

Table des Matières