HTC 450 Manuel D'utilisation page 9

3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
927 - 002 - 14.12.2018
A
B
1. Disconnect the motor cable (A) from the electrical
enclosure.
2. Push the handle on the central hinge and at the
same time fold the top frame forward to transport
position.
A
9