Greencut GTC300X Manuel D'utilisation page 72

72
JOIN THE KNIVES
1. Join the two parts of the milling cutters through the shaft and fix them with the pin and pin.
2. Performs the same procedure for drills on the opposite side.
1
PLACE THE STRAWBERRIES
1. Place the cutters on the side marked by the indicator stickers, R (right), L (left).
2. Align the holes with the machine shafts and secure the cutters with pins and pins.
3. Do the same on the opposite side.
1
PLACE THE PLOUGH DISC
1. Remove the screw from the end of the bur.
2. Align the plough disc on the cutter shaft.
3. Retighten the screw. Join the knives
1
1
2
2 3