Télécharger Imprimer la page

BORETTI BSI 831 Notice D'emploi page 19

Publicité

Les langues disponibles

Les langues disponibles

EN
INSTRUCTION ON MOUTNING AND USE
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility,for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Place a standards
approved bipolar switch with an aperture distance of not less
than 3mm (accessible) from he contacts.
Operation
A
B
C
A:Lights ON/OFF Button: the extractor hood lights are
turned on and off by pressing the button.
B:Engine ON/OFF Button (4 speeds): the extractor
is switched on by
extractor speed
(power)
buttons "C" and "D".
C:Extractor
Speed
(power)
the extractor speed is reduced by pressing the button.
D:Extractor Speed (power) Increase Button: the
extractor speed is increased by pressing the button.
F:Timer Button: the 5-minute timer is activated
by pressing
the
button,
selected; the timer is deactivated by pressing the
same button again.
E:LED indicates the different speeds: green, speed
1; amber, speed 2; red, speed 3; blinking red,
speed 4 (speed timer activated; it stays on for 7
minutes, then it automatically goes back to the last
selected speed.)
Do not use solvents to clean the control.
R5
D
F
E
pressing
the
button.
can
be adjusted using
Reduction
Button:
whatever
the
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The cooker hood should be cleaned regularly internally and
externally.For cleaning use a cloth moistened with denatured
alcohol or neutral liquid detergents. Avoid abrasive detergents.
Warning: Failure to carry out the basic standards of the cleaning
of the cooker hood and replacement of the filters may cause fire
risks. Therefore we recommend observing these instructions.
Anti-grease Filter – must be cleaned once a month, with non
abrasive detergents, by hand or in dishwasher on low temperature
and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version):
The active charcoal filters F are not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
Replacing lightbulbs
Warning! Prior to touching the light bulbs ensure they are cooled
down.
Open the light cover by pressing with a finger the part marked
„ p u s h " .
Replace the dead bulb.
The
Use only a halogen bulb of 20W max (G4), taking care not to
. t ouch it with naked hands.
Close the light cover.
LED light
If the lighting group LED does not work, please contact the
technical service center in order to replace the whole
group.
speed
19

Publicité

loading