CTC BSS 7014 Mode D'emploi page 21

Remote Control
1 Light 1 – 7 brighter
2 Light 1 – 7 darker
3 Turn light on / off
Flashing colour change (all mood light
4 FLASH
colours)
5 STROBE Current mood light flashes
Mood light colour weak
6 FADE
then change to the next colour
7 Toggle mood light colours
8 SMOOTH Smooth colour change
Automatic colour change between the differ­
9
ent mood light colours
10 Play / Pause
11 PAIRING Disconnect paired devices
Turn device on / turn device into standby
12
mode
13 Increase volume
14 Next title
15 Reduce volume
16 Current title from the beginning / previous title
17 "Candlelight"
Every number button selects a different
18 1 – 7
colour
First Use of the Device / Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Sensitive surfaces may be protected by plastic foil. Re­
move this foil.
Preparing the Remote Control for Operation
The lithium cell in the battery compartment of the remote con­
trol has been secured for transport with a foil. This prolongs
the lifetime of the battery. Before initial use please remove
this foil so that the remote control is ready for operation.
Replacing Remote Control Battery
The battery of the remote control is a long­life lithium cell. If
the range of the remote control is reduced during use, please
proceed as follows:
1. Loosen the screw on the battery compartment with a
suitable screw driver.
2. Open the battery compartment on the bottom of the
remote control.
3. Replace the cell by a battery of the same type (CR 2025).
Ensure correct polarity.
BSS7014_IM_CTC
4. Then close the battery lid. Secure the battery compart­
ment lid with the screw.
If the remote control is not used for a prolonged period, re­
move the batteries in order to prevent battery acid leaking.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collec­
tion bin or at your dealer's.
strong weak,
WARNING:
• Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the fire. There
is a danger of explosion!
• Keep batteries away from children. They are not a toy!
• Do not open the batteries by force.
• Avoid contact with metallic objects. (Rings, nails, screws
et cetera.) There is a danger of short-circuiting!
• As a result of a short­circuit batteries may heat up con­
siderably or even catch fire. This may result in burns.
• For your own safety the battery poles should be covered
with adhesive strips during transport.
• If a battery leaks do not rub the liquid into your eyes or
mucous membranes. If hands come into contact with
the liquid they should be washed thoroughly and eyes
rinsed out with clear water; if symptoms persist please
consult a doctor.
Before First Use
Charge the battery before first use. See details in chapter
"Charge Integrated Battery".
The device is powered by the integrated rechargeable lithium
battery. Charge the battery as follows:
1. Flip the rubberised cover open.
2. Insert the charging connector into the DC plug on the bot­
tom of the device. Connect the USB plug to a powered­on
computer. The indicator lamp lights up red and the battery
charges.
3. When the battery has been fully charged, the indicator
lamp (3) turns off.
4. Remove the charger cable from the speaker and PC.
5. Then close the rubberised cover again.
CAUTION:
Never leave the device unattended when it is charging.
NOTE:
• The battery is only charged while the PC is switched on.
• Do not connect the player for a long period of time to a
laptop computer disconnected from mains power Oth­
erwise the laptop computer's battery may be discharged.
• The charging time varies according to battery use.
Charge Integrated Battery
02.11.17
21