Cutting Techniques - Greencut GM650XB Manuel D'utilisation

The cutting tool can be adjusted up to 10 positions: from 120° to 270° from the outer tube as shown in the picture.
See the instructions for adjustment. After each adjustment, always make sure that the retaining clip is in the closed
position.
APPLICATIONS
Never cut branches above your head. Be careful with the branches as they may bounce off you once they fall to the
ground.
• Working posture: Sostenga el asa de control con la mano derecha, y la unidad con la mano izquierda. El brazo
izquierdo debe estar extendió a fin de conseguir la posición más cómoda. Descanse si se siente cansado.
• Preparations: Primero utilice tijeras de podar para cortar las ramas más gruesas.
• Cutting sequence: Si fuese necesario un corte radial, corte poco a poco en varios tiempos.
•

Cutting techniques:

-
Vertical cut: Move the blade up and down in an arc as it moves along the hedge. Use both sides of
the blade.
-
Horizontal cut: Hold the blade at an angle of 0 to 10° while rotating the hedge trimmer horizontally.
Move the blade in an arc towards the inside of the hedge so that the clippings are scattered across the
ground.
89
EN