Marq COLORMAX BAT Guide D'utilisation page 4

Setup
Note: Items not listed under the Introduction > Box Contents are sold separately.
Power Information
Before connecting the fixture to a power outlet, make sure the power cable is not crimped or
damaged. Also, make sure the power outlet's voltage is within the range stated on this product (on
its housing or decal).
Before cleaning or replacing the fuse, disconnect Colormax Bat from its power source. Use a
screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace the
fuse only with a new fuse with the same rating (125 V, 1 A).
Mounting/Rigging
Place the fixture on a flat, stable surface. Make sure all cables are secured and placed so that no one
will trip over them.
Linking
When using multiple Colormax Bat fixtures, you can link ("daisy-chain") them so that each fixture
supplies power and/or sends DMX data to the next one. This helps reduce clutter in your cabling
and save you setup time.
You do not have to link fixtures for both power and DMX control; you can link them for either
purpose independently. For instance, you could link 8 fixtures together for DMX control while linking
only 4 of those same fixtures together for power (powering the other 4 fixtures separately).
Power
Use a standard IEC power cable to connect the Power Out of one fixture to the Power In of another.
As long as the first fixture is connected to a power outlet, any of the linked fixtures can remain off
and still supply power to the next one.
To prevent undue damage to your fuses, we recommend linking no more than 13 fixtures at 110 V or
30 fixtures at 240 V in the same chain.
Power
4