Clatronic VL 3602 Mode D'emploi page 27

Position
The ideal position is a non-slip, flat surface.
Putting into Service
Electrical Connection
• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the device to a duly installed protective contact
socket.
Use
Basic Settings
Set the blower inclination angle before starting the device.
• Hold the motor housing with both hands and tilt it carefully
to the desired position. It clicks audibly into place.
CAUTION:
The tilting angle is about 30 degrees.
Operation
To select the speed, use the pressure switch on the front:
WARNING:
• Always remove the mains plug before cleaning the device.
• If you need to remove the safety guard: Always switch the device
off and remove the mains plug.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the outside of the device with a dry cloth without any
additives.
• If the device is very dirty wet a cloth with water and then
wipe the device dry once you have finished.
To shut off the device, select the position 0.
Fan setting
You have two options:
• Stationary
1. Shut off the device.
2. Pull the control knob upwards.
3. Use the carrying handle to place the device into the
desired position.
• Oscillating
1. Shut off the device.
2. Press the control knob.
NOTE:
The device rotates automatically in the range of
about 90 degrees.
3. To turn off the function, shut off the device and pull the
control knob upwards.
Cleaning
Maintenance and storage
• Clean the appliance as described.
• We recommend that the appliance is kept in its original
packaging if you do not intend to use it for long periods.
• Always store the appliance out of the reach of children, in a
well-ventilated and dry place.Noise development
Noise development
The workplace-related emission value is less than 70 dB(A).
0 off
1 slow
2 medium
3 fast
27