Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRECAUTIONS
Unscrewed or unfastened component may fall or slip off.
Do not let your device get
wet.
Do not leave it in a damp or high humidity environment or under direct sunlight.
Do not place your device near strong magnetic fields, such as television or
radios. This could damage the storage data.
Do not place the device on an unstable surface where it might drop.
ATTENTION !
•
New drives must be formatted before use.
Formatting will erase ALL data on storage device. Please make sure back up
•
all data before performing formatting steps.
•
Refer to your operating system's documentation for more information on
reformatting and partitioning your storage device.
INSTALLATION GUIDE
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may result.
Always handle your hard drive and storage device with caution. Be sure that you are
properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
Use the following instructions to install your drive :
17
Screw out the 2 pcs of
screws on the connector
1
side of the case and take
off the cover.
2 Take out the board.
Install SSD on board as
3
direction 45°C.
Screw up the M.2 disc on
the board.
Insert the board together
4
with the M.2 disc back and
screw up the pair of the
screws.
18
Publicité
Table des Matières
