Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Overview
Refer to the illustrations on page 2 of this manual.
1
power status LED
2
control panel
3
antenna
4
mounting holes
6. Mounting
Have the device installed by a qualified person, respecting EN 60598-2-
17 and all other applicable norms.
The carrying construction must be able to support 10 times the weight
of the device for 1 hour without deforming.
When choosing a location for your device, make sure to avoid a location
exposed to vibrations, dust, hot and cold temperatures, and dampness.
In addition, no powerful transformers or motors must be set up close to
the device.
When installing or setting up the device, make sure that neither the
power cable nor the remote control cable is squashed or damaged by
any sharp edges.
Make sure there is no flammable material within a 0.5 m radius of the
device.
To ensure sufficient ventilation, keep a minimum distance of
approximately 20 cm to other objects around the device and do not
cover the ventilation openings.
Install the device in a location with few passers-by that is inaccessible
to unauthorised persons.
Connect the device to the mains with the power plug. Do not connect it
to a dimming pack.
The installation has to be approved by an expert before the device is
taken into service.
V. 01 – 09/02/2015
VDPLWB
5
6
7
mounting holes
5
power input
DMX input
DMX output
©Velleman nv
Publicité
Table des Matières
