Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.8 Loading Paper
1.
Press the cover open lever while the power is on.
2.
Open the paper cover.
3.
Load the paper roll so that the printable side of the paper is facing down, as shown
by arrow A.
4.
Pull a few cm of paper straight out in the direction of arrow B.
5.
Close the paper cover in the direction of arrow C until you hear a click. Paper is fed
and cut automatically, if the factory settings are set.
CAUTION
Always use the specified types of paper rolls.
Confirm that the paper roll is set correctly.
If the paper is skewed and not coming straight out of the paper cover, open it and
straighten the paper.
Always pull a few cm of paper straight out of the printer if you open the paper cover
while paper is loaded.
Press on the center of the paper cover to close it securely.
Be careful of paper cuts while loading the paper.
Do not touch the print head, manual cutter, or auto cutter while the paper cover is
open. Doing so may cause a burn or cut.
Refer to 5.3 Manual Setting of Memory Switches
— 25 —
Publicité
Table des Matières
Dépannage
