Functional Description - Makita XPH07 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
015120
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly when
•
installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may cause
them to slip off your hands and result in damage to the
tool and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge fully until the
•
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
NOTE:
When the battery cartridge is not removed easily, push
•
it from the opposite side of the button and slide it.
Switch action
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when released.
Do not pull the switch trigger hard without pressing
•
the lock-off lever. This can cause switch breakage.
1. Button
2. Red indicator
3. Battery cartridge
3
015107
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
press the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
For your safety, this tool is equipped with lock-off
•
lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off lever. Return tool to a MAKITA service
center for proper repairs BEFORE further usage.
NEVER tape down or defeat purpose and function
•
of lock-off lever.
Indicating remaining battery capacity
015143
When you turn the tool on, the battery indicator shows
the remaining battery capacity.
The remaining battery capacity is shown as the following table.
Battery indicator status
Blinking
On Off
015146
7
1. Switch trigger
2
1 2. Lock-off lever
1. Battery indicator
1
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery