Installation Instructions - MHTeam DH1-20 Manuel D'instruction

Générateurs d'air chaud directs à gasoil/kérosène
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To assemble the heater, proceed as follows (see Fig. 2):
1、insert the wheel shaft A to the corresponding hole of feet pipe F,insert the spacer D, slide the
wheel B over the wheel shaft A,fix the wheel on the shaft by using spring washer C.
2、Put the heater body on the feet pipe assembly, make sure the holes of handle G point towards the
corresponding holes on the feet pipe respectively.
3、Using the screw H, nut E to fix the feet pipe assembly and handle to the tank.

5. Installation Instructions

Position the heater on a flat, level, non-flammable, solid surface.
Direct-fired heaters are intended for use in outdoor open areas or in indoor well
ventilated areas. For indoor use, provide permanent ventilation openings of at least 25
cm²/kW, equally distributed between floor and high level, with a minimum of 250 cm².
Minimum Opening Size
Only install the heater in normal upright position.
Do not place the heater near walls, corners or low ceilings.
Do not place the heater below a socket outlet.
Do not place the heater on moving vehicles or where it can tip over.
Keep the heater away from flammable, combustible, explosive or corrosive materials.
Keep the heater away from curtains or similar materials that could block the air inlet and
outlet.
Never block or restrict the air inlet and outlet for any reason.
Keep the power cable away from heat sources, sharp edges, cutting and moving parts.
Do not expose directly to the weather or to excessive humidity.
Do not place the heater in the immediate surroundings of a bath, shower or swimming
pool.
Follow general and special fire safety regulations in force in all fields of applications. In
any case ensure the following minimum safety clearances from materials or objects in
the surroundings of the heater:
DH1-20
600 cm²
Side:
Air inlet side:
Top:
Pos.
Description
A
Wheel shaft
B
Wheel
C
Spring washer
D
Spacer
E
Nut M5
F
Feet pipe
G
Handle
H
Screw M5
I
Heater body
Fig.2
DH1-30
800 cm²
0.6 m
1 m
1.5 m
Qty
1
2
2
2
6
1
1
5
1
DH1-50
1200 cm²

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dh1-30Dh1-50

Table des Matières