Using Your Electronic Control; Starting Your Appliance; Sleep Mode; Turning Your Appliance "On" Or "Off - AGA marvel Professional MP15BCG4 Série Instructions D'installation, D'utilisation Et D'entretien

Temp
Minus
keypad
Power Failure
Starting your appliance (single and dual
zone):
Plug the appliance power cord into a 115 volt wall outlet.
Your appliance is shipped from the factory in the "On" posi-
tion and will begin start-up of cooling as soon as power is
supplied. If the appliance does not start, confirm that the
wall outlet has power, and that the control is in the "On"
position, (See "Turning your appliance On and Off" below).
The control display is covered with a clear plastic film. This
film may be removed by carefully lifting the film at a corner.
On initial power up, the control display will indicate a
"Power Failure" alarm. This is a normal condition as the ap-
pliance was powered-up at the factory for quality inspection
and then removed from power. A momentary press of the
"On/Off" keypad will reset this alarm condition. (See Alarms
section on page 11).
Sleep mode (single and dual zone):
If no keypads are pressed for 60 seconds, the display will
enter sleep mode to conserve power. The control panel will
go dark with the exception of the system status "OK" indi-
cator which will remain enabled. Alarm conditions will wake
the display, (see alarms on page 11).
To make the following changes to the control settings
(turning the appliance ON/OFF, adjusting the tempera-
ture, changing the interior lights, and activating vaca-
tion mode), the control must be awake.
To wake the display press any keypad. A confirm tone will
sound, and the current storage compartment temperature
will be displayed.

USING YOUR ELECTRONIC CONTROL

Upper/Lower
Temp zones
On/Off Plus (Dual Zone
keypad keypad models only)
Electronic control
ALARM RESET
Lights
Lock
keypad
Display Area keypad
Figure 10
The sleep mode can be disabled if you prefer to have the
display on continuously. Press and hold the "Lock" key-
pad until the display goes past "Loc" and reads "nSL". To
enable the sleep mode, repeat the instruction, again going
past "Loc" until the display reads "SLP".
Turning your appliance ON and OFF (single
and dual zone):
If the appliance is "On", (and out of sleep mode) the tem-
perature will be shown in the display area of the control.
To turn the appliance "Off", press and hold the "On/Off"
keypad for 4-seconds. "OFF" will now be displayed on the
control.
To turn the appliance "On", press and hold the "On/Off"
keypad for 4-seconds.
8
System Status
indicators