Filling The Reservoir Before Use - Reliable PRONTO 100CH Mode D'emploi

FILLING THE RESERVOIR BEFORE USE

• Make sure that the appliance is unplugged.
• Open the lid of the "Comfort Safety" System (5), check that the "Comfort
Safety" system full indicator/red pin (6) is NOT visible, fill the reservoir with
1 beaker (17) (Fig.1). Remember that the water level should not exceed the
maximum marker on the beaker.
• Close the lid of the "Comfort Safety" system (5).
Note: In the event that water does not enter the tank, power on the unit and
depress the trigger for 30 seconds in order to remove air pressure.
IMPORTANT! For the unit to function:
• The blue lid for the "Comfort Safety" system must be CLOSED.
• Red safety pin must be visible after water has been added
and pilot light turns off.
USER INSTRUCTIONS
• Attach the desired cleaning accessory and plug in the appliance.
• The pilot light (4) will come on indicating that the appliance is plugged in.
• When the steam cleaner/fabric steamer has the pressure required to operate,
the pilot light (4) will go off indicating that you can start to use it. This
operation will take approximately 2 minutes. During use, the pilot light will
switch on and off, indicating that the steamer is recovering the necessary
pressure.
• Press steam release lock (6.1) to the left or right.
• Press the steam control (2) to obtain steam.
• We recommend pressing the control (2) repeatedly for short bursts rather
than just a few times for longer periods, so as to maintain pressure in the
boiler and increase the performance of the steam.
• When you finish using the steam cleaner/fabric steamer, unplug it and wait for
it to cool down before removing the accessories.
• We recommend that you empty the water tank if you are not going to use the
appliance again for an extended period of time.
06