Table des Matières
Publicité
GAS (LPG) TANK INFORMATION
1 Maximum diameter: 30 cm
2 Maximum height:
3 Maximum NET Weight: 10 kg
STORAGE (after use)
•
Turn OFF the appliance.
•
Disconnect LPG cylinder.
•
Store the appliance in a cool dry place away from
direct sunlight; store it upright in an area sheltered
from direct contact with inclement weather (such as
rain, sleet, hail, snow, dust and debris).
•
If desired, cover to protect exterior surfaces and to
prevent build up in air passages.
•
Note: Wait until appliance is cool before covering.
During periods of extended inactivity or when transporting:
•
Turn OFF the appliance
•
Disconnect LPG cylinder and move to a secure,
well ventilated location outdoors. DO NOT store in a
location that will exceed 50 °C.
•
Store appliance upright in an area sheltered from
direct contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
•
If desired, cover appliance to protect exterior
60 cm
surfaces and to prevent build up in air passages.
•
Note: Wait until appliance is cool before covering.
•
.
•
•
•
5
Connecting gas circuit to LPG cylinder
Keep at hand suitable crossed screwdriver, adjustable
spanners, pliers and wrenches. Before assembly, make
sure all protection packing material has been removed.
Flexible gas hose(1763-1) and clamps (if necessary) are
supplied with this appliance and must be used, according
to National Rules in force. You need to purchase one gas
regulator and one gas cylinder. The gas regulator has to
be set according to specific gas category (see on page
2) and proper gas consumption (g/h) specification. The
LPG cylinder should be standard one. Recommend to use
Less than 10kg. Replacement must be that specified in
"Gas Requirements" section of this Instruction Manual. Be
careful: do not kink flexible gas rubber pipe of gas circuit. If
pipe holder should not be provided, thread of the gas inlet
connection will be in line with Standards ISO 7-1 or ISO
228-1, according to National Rules in force of the country
of destination.
Make sure appliance is turned "OFF" before assembling.
Connect the hose to the appliance and the regulator.
Tighten the screw of the hose clamp with a screwdriver.
Connect the regulator to LPG cylinder by hand. And
Hand tighten only.
Publicité
Table des Matières
