Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Proper Hand Position (Fig. C)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
9
and one hand on the back of the battery.
Fig. C
Trigger Switch and Forward/Reverse
Button (Fig. D)
•
The drill is turned ON and OFF by pulling and releasing
the trigger switch
. The farther the trigger is
1
depressed, the higher the speed of the drill.
•
A forward/reverse control button
rotational direction of the tool and also serves as a lock
off button.
•
To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
•
To select reverse, depress the forward/reverse control
button on the left side of the tool.
•
The center position of the control button locks the tool
in the off position. When changing the position of the
control button, be sure the trigger is released
Fig. D
1
8
Speed Selector (Fig. E, F)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
•
•
nOTE: Do not change gears when tool is running.
If you are having trouble changing gears, make
sure that the speed selector is either completely
pushed forward or completely pushed back.
Fig. E
9
Fig. F
2
determines the
Keyless Chuck (Fig. G–I)
To insert a drill bit or other accessory:
1. Grasp the keyless chuck
2
2. Insert the bit or other accessory fully into the chuck, and
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
away from the chuck.
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
WARNING: Make certain the battery pack is removed
to prevent tool actuation before installing or
removing accessories.
and rotate it in the
6
counterclockwise direction, as viewed from the
chuck end.
tighten securely by rotating the chuck in the clockwise
direction as viewed from the chuck end.
4
4
4
Publicité
Table des Matières
