Fiamma F65S Instructions De Montage page 13

EN Instructions for use
FR
Mode d'emploi
ES Instrucciones de uso
EN
Fig. 1 : In order to avoid unnecessary strain on the awning as well as on the
wall of the vehicle, we suggest to take out the legs at about 1 m from the
!
opening.
Fig. 2 : Grasp the leg near its hinge-joint and pull it toward you.
Fig. 3 : Unhook the leg.
Fig. 4 : Lower the leg as shown in the figure (pages 17).
Fig. 5 : After unrolling the awning completely, adjust the legs at the chosen
height.
Fig. 6 :To avoid the awning being lifted up by an unexpected gust of wind,
it is necessary to secure the legs to the ground with the provided
hooks. For safety's sake, we strongly advise you also use some
!
storm cords in the upper part of each support leg or anchor the
awning with the Fiamma Tie-Down Kit strap.
Fig. 7 : If you want to fasten the support legs to the vehicle, put the
leg feet into the wall brackets. The brackets can be fixed only in
reinforced points.
Fig. 8 : We remind you that the awning is a sun protection, so please roll
up your awning in case of rain, wind or snow. Otherwise, please
take the following precautions: lower one side of your awning, so
that water can flow away and place the tension rafter as
shown in the figure (not included for all awning lengths), (pages 21).
Fig. 9 : Make sure that the awning perfectly rolls in: when it is,
the red indicators in the front profile ends are no longer visible.
!
Before leaving, make sure the awning is correctly closed.
A damaged fabric does not allow the awning to perfectly roll in.
!
Never use the awning with a damaged canopy.
Wash the canopy with light cleaning detergent.
! In case of problems, please contact the dealer closest to you or
the address in the last page.
ATTENTION: We remind you that the awning is designed
to protect from the sun, and not from rain, wind or snow.
In these cases, we recommend to roll it up!
Fiammastore
13