THOMSON DIGITAL+ THBDH07DPB Notice D'utilisation page 27

1.Place the product in an upright position on a flat, steady, stable, heat-resistant
surface. Make sure there is nothing flammable or heat sensitive within 1 meter.
Operating the product in any other position could cause a hazard.
2. Take out the power cord from the cable storage, and insert the mains plug into a
suitable wall socket. Press the power switch (red color) to position I. Always ensure the
mains cable is fully unwound and outside of the cable storage when the product is in
use.
3. Press the power button ( ) once to start the heater on High Power(
Run. If left at this setting , the unit will run continuously on High Power
4. Press the power button ( ) again to change to Lower Power ( ), Continuous Run. If
left at this setting, the unit will run continuously on Lower Power
5. Press the power button ( ) a third time to turn the heater OFF.
ADJUST TEMPERATURE
1. Press the MODE button until the temperature icon flashes.
+
2. Use the " " and "
3. The temperature icon will stop blinking and the current ambient
temperature will appear after the desired temperature is set.
4. The heater will turn-off shortly after the room temperature is higher
than the desired temperature. The temperature display will flash.
5. The heater will turn back on when the room temperature drops below the desired
temperature. The temperature display will then stop flashing and keep displaying the
room temperature.
Note: The LCD display shows the ambient temperature near the heater, to achieve
optimal indoor temperature, it is advisable to increase the target temperature during
the first hour of use of the device, then you can adjust the temperature.
TIMER (AUTO-OFF)
This function should only be set if you desire that the heater be
automatically shut off after a certain period of time (1 to 24 hours
from the time the function is set)
NOTE: Always set the desired temperature prior to setting the
Timer so that the heater will shut off at the desired temperature setting.
Press the MODE button until the timer icon blinks.
The hour display and Auto Off icon will appear.
+
-
Use the " " and "
This function will activate once the timer icon stops blinking. The heater will
automatically turn-off when time runs out.
TIMER (AUTO-ON)
This function provides a delayed start option and should only be
set if you desire that the heater be automatically turned ON after
a certain period of time (1 to 24 hours from the time the function
is set).NOTE: Always set the desired temperature prior to setting
the timer so that the heater will turn on at the desired temperature setting.
Press the MODE button until the timer icon blinks. The hour display and Auto On icon will
appear.
+
-
Use the " " and "
function will activate once the timer icon stops blinking. The heater will automatically
turn on when time expires.
-
" button to set the desired temperature.
" button to set the heater operation time between 1 and 24 hours.
" button to set the heater start time between 1 and 24 hours. This
( )
), Continuous
GB-11