General Controls - ION TTUSB10 Guide D'utilisation Rapide

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Make sure all items listed on the front of this guide are included in the box.
o
READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT
o
Go to http://www.ion-audio.com for product registration.
o
INTRODUCTION
The USB turntable connects directly to your computer to turn your treasured vinyl recordings into digital
music. We have included two software packages to aid you in converting your vinyl recordings:
EZ Vinyl / Tape Converter (PC only) or EZ Audio Converter (Mac only) is the quickest and easiest way to
turn your recordings into digital media. EZ Vinyl / Tape Converter or EZ Audio Converter conveniently saves
your recordings in your iTunes* library. Novice users may find this application preferable. On the CD, we
have included a handy Quickstart Guide with step-by-step instructions on software installation and operation.
To install the software: simply insert the included CD into your computer
and follow the on-screen instructions. After you finish converting your
vinyl, you can then burn to CD or load onto portable media devices.

GENERAL CONTROLS

1.
Power Cable: This power cable should
be plugged into a wall receptacle AFTER
all audio connections are made.
2.
RCA Audio Output Cables: These
cables should be plugged into the audio
inputs of your home stereo system.
(Please note: you can still copy records to
your computer, even if the audio outputs
of the turntable are not connected to a
stereo system. It is also possible to hear
your records through your computer, as
long as you have configured your
computer's
sound
options correctly
3.
There is a switch on the bottom panel,
next to the RCA cables, that selects
between PHONO/LINE. Use PHONO
level for plugging into a turntable input on
a home stereo. Use the LINE level for
plugging
into
WARNING: You may damage your
receiver if you plug in a LINE level into
a PHONO input.
4.
Gain: This knob can be used to adjust
the gain level of the audio signal from the
turntable. If the audio from the turntable
is too quiet or too loud, use this knob to
adjust the volume setting.
5.
USB Audio Output: Use the included
USB Cable to connect your turntable to
your computer. For transferring your vinyl records to your computer, we have provided two different
software packages on the included CD.
6.
Power Button: Use this button to power the turntable on and off.
7.
Platter: This platter must be securely fastened to the turntable prior to operation. The Motor Drive Belt
can be found on the drive ring underneath the platter. See SETUP INSTRUCTIONS for detailed
information on installing the Motor Drive Belt.
8.
Start/Stop Button: This button starts and stops the turntable motor. If the button seems not to be
functioning, check to make sure that the Motor Drive Belt is properly installed in the SETUP
INSTRUCTIONS.
9.
1/8" Stereo Line Input: Connect Tape Players, Reel to Reel, or any other audio source here. This
signal is sent to the computer through the USB connection. Make sure that your phono cartridge is
installed while using this input for maximum sound quality. Also make sure that your RCA jacks
are either plugged into an input device or not in contact with metal.
Note: The 1/8" audio input is not routed to the turntable's RCA output jacks, only to your computer via
USB.
(ENGLISH) QUICK START GUIDE
input
and
output
CD/AUX/TAPE
inputs.
* iTunes and iPod are trademarks of
Apple, Inc., registered in the U.S.A. and
other countries.
3

Publicité

Table des Matières
loading

Table des Matières