Helpful Hints - Ducane Meridian 2020806 Guide De L'utilisateur

NORMAL OPERATION NORMAL OPERATION
Flare Ups
Any time you cook fatty foods over an open fl ame, you can expect fl are ups. Flare ups
are caused by the fl ash which occurs when the natural juices fall on the heat distribu-
tion plates. Controlled fl are ups give foods their delicious outdoor fl avor and appear-
ance. Excessive fl are ups may occur when your grill is not level or when cooking fatty
foods such as spare ribs and chicken parts, especially if the cooking temperature is set
too high. These fl are ups should be controlled or your food will burn, although it will
not burn nearly as much as you might think even in the direct fl ame.
WARNING: Do not spray or pour any liquid into the cooking
box to control flare ups. Doing so will void your warranty and
may damage the grill.
To help control fl are ups, we suggest using leaner cuts of meats and trimming excess
fat from the meats to be grilled. Also, your grill should be level. If fl are ups do occur,
use the "Low" control setting and relocate the meat on the cooking grid until the fl are
ups have subsided.
1. To prevent food from sticking to the grid, preheat the cooking surface with the hood
down for 10 minutes. Place the meat product on the grid and allow it to remain
there for at least half of the suggested grilling time.
2. It is unnecessary to keep fl ipping meat products— allow them to sear and seal in
their juices, then halfway through the cooking period, with a spatula, fl ip the meat
product onto its other side. When grilling chicken, always place the meat side on the
grill fi rst.
3. A light coating of oil applied to any of the meat products prior to grilling will also
help. The use of a commercial spray cooking product is also helpful. This spray
should only be used prior to lighting your grill but never during the cooking period.
Use of spray cooking product can leave a black stain on areas of your cook grate.
This is not harmful and does not affect cooking; however, if this becomes an appear-
ance problem, the best way to remove the discoloration is by placing the cook grate
in a self-cleaning oven during the clean cycle.

HELPFUL HINTS

HELPFUL HINTS
Storing Natural Gas Grills
After you have fi nished cooking and have cleaned your grill, (see Maintenance section
– for cleaning), turn your grill off at your appliance control knob. It is strongly recom-
mended that the inline fi eld installed cutoff valve also be turned off when the grill is
not in use.
When the portable grill is to be stored indoors, the connection between the hose and
the gas supply line must be broken. While the special fi tting will stop the gas fl ow when
the hose connection is removed, it is highly recommended you turn the gas supply off
prior to disconnecting the hose assembly. To protect the gas fi tting, it is necessary to
insert the plastic plug (supplied with 10' hose package) into the female quick connect.
The male end of the hose must be protected by placing the plastic cap (supplied with
10' hose package) over the brass fi tting on the end of the hose.
Gas Valve Orifi ce
WARNING: Any alteration made to the orifice(s) such as drill-
ing it out, will void your warranty and may result in serious
bodily injury or death, or in a fire or an explosion causing
damage to property.
20
When Using the Rotisserie
WARNING: The rotisserie motor must be stored indoors when
not in use. Do not leave it mounted on the grill.
1. When using the rotisserie, the hood must be closed except when basting.
2. Important: Always light rotisserie burner with the hood in the full open position.
3. It is important to evenly balance the meat on the spit rod. This can be diffi cult
especially with a turkey. Proper balancing will lead to more even cooking and
prolong the life of the rotisserie motor.
4. Pliers may be used to tighten thumb screws on meat forks when larger cuts of
meat are being rotissed.
5. Use twine to secure the meat on the spit rod, especially fowl or other cuts of meat
that require tying.
Rotisserie Bracket (Motor Bracket Side)
When mounting the spit rod motor onto the motor bracket (right side burner box), the
ears of the motor bracket must be fully inserted into the spit motor slots.
Accomplish this by sliding the spit motor down to the stops of the spit motor bracket.
The spit rod should not be making surface contact with the slot in the spit motor
bracket. See Assembly Guide for more information.
Shelf/Shelves
Do not use shelf or shelves as a cutting board. Clean with soap and water.
Moving Portable Grills
When your grill is not in use and you wish to relocate it, we recommend you push the
grill by the side shelf.
CAUTION: If your grill is portable and you are using a gas
tank, make sure you turn the appliance control knobs first,
and then the gas supply tank. On permanent installations, it
is strongly recommended that the inline field installed cutoff
valve also be turned off when the grill is not in use.
www.ducane.com