Control Panel And Features; Add Garment; Start/Pause Button - Whirlpool cabrio Série Guide D'utilisation Et D'entretien

Control Panel and Features

Not all features and cycles are available on all models.
1
NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are
registered, touch the control panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name
until the desired section is illuminated.
POWER BUTTON
1
Touch to turn the washer ON. Touching once while the
washer is on will cancel the current cycle, touching twice
will turn the washer OFF.
2 WHAT TO WASH
Use these options to describe the type of items you are
loading into the washer. See "Cycle Guide" for detailed
descriptions of options.

ADD GARMENT

3
When Add Garment is lit, you may pause the washer, open
the lid, and add items. Touch and hold START to start the
washer again.
TIME/STATUS DISPLAY
The Estimated Time Remaining display shows the time
required for the cycle to complete. Factors such as load
size and water pressure may affect the time shown in
the display. Tightly packed loads, unbalanced loads, or
excessive suds may cause the washer to adjust the cycle
time, as well.
If you have set a delay start to the cycle, the Estimated
Time Remaining display will show the delay time adjusted.
When the cycle is complete, the Done indicator will light
until the lid is opened.
The Lid Lock indicator lights up when the lid is locked
and cannot be opened. If you need to open the lid,
touch START/PAUSE. The lid will unlock once the washer
movement has stopped. This may take several minutes
if the load was spinning at high speed. Touch START/
PAUSE again to restart the cycle.
HOW TO WASH
4
Use these options to describe the method of washing your
load. See "Cycle Guide" for detailed descriptions.

START/PAUSE BUTTON

5
Touch START to begin the selected cycle; touch again to
pause a cycle.
2
6
3
7
OPTIONS
6
You may add or remove options for each cycle. Not all
options can be used with all cycles, and some are preset
to work with certain cycles.
DELAY START
Touch Delay Start to delay the start of the wash cycle by
up to 12 hours. Touch Delay Start until a "0" appears in
the status display to turn off, or touch POWER.
END BEEP
End Beep signals that a cycle has completed.
STEAM CLEAN
The Steam Clean option adds additional soak and wash
time to many cycles to help remove tough stains, as well
as a steam boost for added cleaning power. Steam Clean
uses a heater within the washer to maintain the selected
temperature setting throughout the wash period. Steam
Clean may be selected as an option with other cycles.
ADDITIVES - OXI
Select the Oxi option so that it is added to the load at the
correct time.
UTILITY TOOLS
Clean Washer
Use this every 30 washes to keep the inside of your
washer fresh and clean. This cycle uses a higher water
level. Use with affresh
chlorine bleach to thoroughly clean the inside of your
washer. This cycle should not be interrupted. See
"Washer Care."
IMPORTANT: Do not place garments or other items
in the washer during the Clean Washer cycle. Use this
cycle with an empty wash tub.
Rinse & Spin
Combines a rinse and high speed spin for loads
requiring an additional rinse cycle or to complete
a load after power interruption. Also use for loads
that require rinsing only.
4 5
6
Washer Cleaner tablet or liquid
®
5