Personal Safety Precautions; Charging The Internal Battery Of The Jump Starter - Schumacher Electric SJ1329 Manuel D'utilisation

2. PERSONAL SAFETY PRECAUTIONS

2.1 Wear complete eye protection and
protective clothing when working near
lead-acid batteries. Always have someone
nearby for help.
2.2 Have plenty of fresh water, soap and
baking soda nearby for use, in case battery
acid contacts your eyes, skin, or clothing.
Wash immediately with soap and water
and seek medical attention.
2.3 If battery acid comes in contact with eyes,
flush eyes immediately for a minimum 10
minutes and get medical attention.
3. FEATURES

4. CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER

IMPORTANT:
CHARGE IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE AND
EVERY 30 DAYS, TO KEEP THE UNIT'S
INTERNAL BATTERY FULLY CHARGED
AND PROLONG BATTERY LIFE.
4.1 CHECKING THE LEVEL
OF THE INTERNAL BATTERY
Press the Battery Status button on the
front of the unit. The LEDs will indicate the
current charge level as follows:
RED – less than 20% of full charge;
immediately charge the unit.
YELLOW/ORANGE – 20-80% of full
charge.
GREEN – more than 80% of full charge.
2.4 Neutralize any acid spills thoroughly with
2.5 Remove all personal metal items from your
2.6 Never smoke or allow a spark or flame in
2.7 WARNING: This product contains one
1 2
3
4
5
6
4.2 CHARGING THE INTERNAL BATTERY
• 3 •
baking soda before attempting to clean up.
body, such as rings, bracelets, necklaces
and watches. A battery can produce a
short circuit current high enough to weld a
ring to metal, causing a severe burn.
the vicinity of the battery or engine.
or more chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
1. Built-in work light
2. Battery status indicators
3. Battery status button
4. Worklight ON/OFF switch
5. 12V DC power outlet
6. Battery clamps
Charge the unit's internal battery using an
extension cord (not included).
NOTE: Use of an improper extension
cord could result in a risk of fire and
electric shock.
1. To charge, flip the AC connector on
the back of the unit DOWN and plug in
an 18 AWG or larger extension cord.
2. Plug the extension cord into a 120VAC
electrical wall outlet.
3. While the jump starter is charging, the
RED LED will be on. Complete charging
may take up to 72 hours. When the
RED LED turns off, the jump starter is
ready to use.
4. When the internal battery is fully
charged, the charger will automatically
go into maintain mode and maintain
the battery at full charge without
damaging it. When in maintain mode,
the GREEN LED will light, as long as
there is an AC cord connected to the
charging port.
5. Charge the jump starter as soon as
possible after use.