Publicité
Les langues disponibles
Les langues disponibles
1. Settings buttons.
2. Display of measurement of CO2 concentration in ppm in the room.
3. Display of the relative humidity of the room.
4. Micro USB charging port for the battery (under the base).
5. Display of the ambient temperature of the room.
6. Battery indicator.
Functions of settings buttons:
ON/OFF functions to switch the meter on and off.
In standby mode: allows you to change how the unit of temperature is displayed
(°C/°F).
In configuration mode: allows you to increase the display value by +1.
In standby mode: allows you to enable/ disable the alarm.
In configuration mode: allows you to select the display value to the left.
In configuration mode: allows you to select the display value to the right .
Allows you to record data.
In configuration mode: allows you to reduce the display value by -1.
In standby mode: allows you to select the configuration mode.
MODE
In configuration mode: allows you to confirm and move to the next settings.
Remove the product from the packaging, check all the accessories are included and
follow the instructions.
Step 1: Fully charge the battery. Connect the USB end of the cable to the adapter
then plug the adapter into a socket (230 V ~50 Hz) and the end of the cable into the
micro USB port under the product (4). Unscrew the base to make this easier if
necessary.
Press
to turn the meter on. A 30-second countdown is shown on the display for the
device to warm up and adjust.
Important: Do not adjust settings or use the meter when it is warming up.
The battery indicator (6) indicates the progress of charging. The full charge time is 4
hours.
After shipping and removing the protective packaging, the product must be placed in a
well-ventilated area for a few minutes prior to setting and use so the sensors are clear
and ready for use.
Measurements are shown on the display when the countdown is complete.
Imported by:
AIC International - 44980 Ste Luce sur Loire - France
Publicité
