1. Lower hinge (right)
4. Door
7. Top hinge (left)
1. Open the door to 90 degrees, take out two screws (2) from the lower door axis (3), remove the door
(4) and door axis (Fig. A). Position the door (4) safely (Fig. A and B).
2. Take out three hinge screws (6) from the top hinge (right) (5) and remove it as well as the lower hinge
(right) (Fig. C).
3. Install the spare top hinge (left) (7) on the top left of the cabinet with three screws (Fig. D). Install the
spare lower hinge (left) (8) according to the above procedure (Fig. E).
4. The door opens to 180 degrees. Install the door in the same way as it was removed and fix it so that
the door is aligned.
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
20°C.
"RUN"
Power indicator
button
To turn the appliance on or off.
Press and hold this button for around 3 seconds.
button
Inner lighting control button
Display
Electronic temperature display
button
+ temperature setting button
button
- temperature setting button
You can choose the desired chamber temperature by using the "
selected increases/decreases by 1°C with each button press.
Temperatures between 5 and 20°C can be selected. Once the desired temperature has been selected,
the display will flash for 5s before showing the current internal cooler temperature. The set temperature
can be viewed at any time by pressing and holding the temperature select buttons for 5s.
2. Screws
5. Top hinge (right)
8. Lower hinge (left)
3. Door axis
6. Hinge screws
/
" buttons. The temperature
38