Casanoov TANKER B350 Mode D'emploi page 11

The gate motor is not applicable to a gate which is ineffcient or unsafe, neither to solve the defects
due to incorrect installation nor poor maintenance.
Check the following items before going for installtion:
1) Make sure the weight and dimension of the gate conform to the operation range of the gate
motor. Don't use the gate mootr if the gate specifications do not meet the requirements.
2) Make sure the gate structure conform to the criteria of automatic operation and force regula-
tions.
3) Make sure there is no serious friction existing in the opening or closing travel of the gate leaves.
4) Make sure the gate is at horizontal level that the gate will not move aside at any position.
5) Make sure the gate can bear the impact of the motor torque when it is installed on any hole of
the bracket which the surface is sufficiently sturdy.
6) Make sure the photo sensors are installed on flat surfaces to ensure the two ends of receiving
and transmitting corresponded to each other.
7) Check the dimensions of the motors as below:
8) Make sure to leave enough space when the gate is opening.
If the gate is OPENED OUTWARD,
please leave at least 70mm between
the post brackets and the gate.
Installation of Motor's Arms to Gates
EN
11