Casanoov TANKER B350 Mode D'emploi page 14

11) Clamp and fix the motor front plate on the door temporarily
12) Lift up the motor and insert the screws into the front plate.
13) Open the gear motor cover and release the screws. Take out the bolt as below figure. Lift the motor
overhead and push the gate to the end until the screw holes of the motor end matches the holes on the
rear plate as shown in Figure. Fasten the motor to the rear plate with bolt and screw
14) Fasten the nut tightly and loosen if for
half round for motor supporting in rotating
15) Fasten the motor front end to the front
plate with the bolt (A) and nut (B) tightly.
Fully tighten the screw.
16) Connect the motor power cable as shown
17) Close the gear motor cover by tightening
the two screws
EN
14