VINCENT CD-S1.2 Manuel D'utilisation page 40

A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (7) on the
front of the appliance.
All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Unsuitable head-
phones with too low impedance may damage the amplifier or produce such unexpectedly loud volume
that your hearing may be damaged. The volume should be reduced (8) for safety reasons before a set of
phones is connected.
CONNECTION OF SOURCE DEVICES OVER
The integrated D/A converter makes it possible to receive also digital audio signals via an optical and/or
coaxial cable and to transmit them analogously to the amplifier. Here, the "Optical IN" and "Coaxial
IN" (17) connections serve as input.
Digital audio source with optical signal connection
CD-S1.2
Digital audio source with coaxial signal connection
CD-S1.2
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and frequency
can be read on the back of the device beside the socket for the mains. If the electricity supply is appropriate,
push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device.
Connect the other end of the mains cable to a mains socket.
Vincent
40
CONNECTING HEADPHONES
OPTICAL IN AND COAXIAL IN
Optical digital
cable
DIGITAL OUT
Coaxial
Digital cable
(RCA)
DIGITAL OUT
DVD, SACD, CD,
TV/Radioreceiver
DVD, SACD, CD,
TV/Radioreceiver