Futurelight PHS-260 Pro-Head-Spot Mode D'emploi page 42

Install the safety bond by inserting the quick link in the hole on the bottom of the base Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
Screw one clamp each via a M12 screw and nut onto the Omega-clamps.
Insert the quick-lock fasteners of the first Omega-clamp into the respective holes
on the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
Install the second Omega-clamp.
DANGER TO LIFE!
42/116 00041987.DOC, Version 1.0