Troubleshooting - Danby Designer DCF081A1WDD Guide D'utilisation Et Soins De Propriètaire

Care and Maintenance
SOME IMPORTANT RULES FOR THE CORRECT USE OF THE
FREEZER
• Never place hot foods in the freezer.
• Never place spoiled foods in the unit.
• Don't overload the unit.
• Don't open the lid unless necessary.
• Should the freezer be stored without use for long periods, it is sug-
gested, after a careful cleaning, to leave the lid open to allow the air
to circulate inside the unit in order to avoid the possibility of
condensation, mold or odors.

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
PROBLEM
1) Does not work.
2) Freezer runs
continuously.
3) Internal temperature
not cold enough.
Tel: 1-800-26- (1-800-263-2629).
POSSIBLE CAUSE POSSIBLE CAUSE
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being used.
• Temperature set too low.
• Lid is not closed.
• Hot food inserted.
• Lid opened too long or too
often.
• Close proximity to heat
source or direct sunlight.
• No power to unit.
• Power cord is unplugged.
• Temperature set too high.
• Lid is not closed.
• Hot food inserted.
• Lid opened too long or too
often.
• Air flow obstruction.
• Wrong voltage is being used.
• Close proximity to heat
source or direct sunlight.
6
POSSIBLE SOLUTION SOLUTION
• Check connection of power
cord to power source.
• Plug in unit.
• Use proper voltage.
• Set temperature control to
warmer setting
• Close lid securely.
• Be sure food is at room
temperature before inserting.
• Minimize lid openings/
duration.
• Do not place unit close to
heat sources or direct sun
light.
• Check connection of power
cord to power source.
• Plug in unit.
• Check setting and increase
as needed.
• Close lid securely.
• Be sure that food is at room
temperature.
• Minimize lid openings/
duration.
• Allow room for air to
circulate around unit.
• Use proper voltage.
• Do not place unit close to
heat sources or direct
sunlight.