Grex G9.1 Evolve Sécurité Et Instructions D'utilisation page 17

1.6 Hold the left front part of the liner and pull it upwards in order to remove the liner flap from
the support fixed to the inner polystyrene shell (Fig. 18). Repeat the same steps to remove
the central and right front flap.
1.7 Completely remove the liner from the helmet.
2 ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner shell and
push it slightly downwards until it is completely locked (Fig. 18). Follow the same steps for
the central and right front flap.
2.3 Insert the rear right, central and left flaps of the liner into the relevant support seats in the hel-
met neck-ring area (Fig. 17). To perform this step, act as follows: slightly deform the shell sea-
ling edge and push the flaps until they are completely hooked to the support.
2.4 Hook the fixing button located in the back of the cheek pad near the roll neck to the seat
fitted on the shell's internal wall (Fig 16).
2.5 Insert the right and left side flaps of the comfort padding by pushing them between the inner
and outer shell (Fig. 15).
2.6 Hook the roll-neck eyelet to the frame fixed to the outer shell (Fig. 14), making sure that the
frame central hole is free.
Note: Check the correct assembly of the liner front area by lifting and lowering the VPS.
These movements should be smooth. If this is not the case, repeat the steps 1.6 and 2.2.
2.7 Insert the left chin strap in the slot of the left cheek pad by pulling towards the inside of the
helmet; then push the padding near the snap fastener on its back so that it is hooked in the
hooking seat of the frame fixed to the shell (Fig. 13).
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not been correctly
and completely restored.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse off with cold water and dry up at room temperature away from direct sunrays.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material, in fact it is apt to change or get
partially destroyed to help absorb shocks.
- Use a wet cloth to clean it and let it dry at room temperature away from direct sunrays.
- Do not modify the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
17