Venmar VBLDN1 Manuel D'installation, D'utilisation Et D'entretien page 11

5 ] Remove the parts bag, taped on the inner back of hood, near the left corner. Remove the EZ1
brackets from inside the hood by cutting off the tie wrap. Discard the tie wrap.
PARTS BAG LOCATION
6 ] Remove Electrical Power Cable Knockout from top (vertical wiring) or back (horizontal wiring)
of hood. For knockout removed from back of hood, install an appropriate strain relief,
1/2" diameter (not included). For knockout removed from top of hood, the strain relief will be
installed later.
ELECTRICAL
POWER CABLE
KNOCKOUT
EZ1 BRACKETS
11